OptiMate 5 Select
SILVER series: 8-step 6V 4A / 12V 3A sealed battery saving charger & maintainer
OptiMate 5 Select will save, charge and maintain all 6V and 12V lead-acid batteries.
Ideal for 6V and 12V deep cycle and starter (SLI) lead-acid batteries found in the vehicles / craft and equipment above.
Select the right charge voltage for any type of 6V and 12V lead-acid battery, from standard flooded, AGM, GEL to deep cycle – Selection remains in memory even if AC power is lost.
Fully automatic multi-step program brings the battery safely to full charge – Connect to the battery and OptiMate 5 Select does the rest, no supervision required!
All OptiMate battery chargers listed below accept global input of 100-240Vac 50-60Hz, only the power plug TYPE is different to comply with national / regional electrical safety laws.
STD, AGM and GEL 6V and 12V lead-acid batteries used for engine start & deep cycle applications. (Link: Learn here about batteries, this will be at www.optimate1.com/batteries).
For 6V batteries from 12Ah to 192 Ah for 24-7 battery maintenance. Can recharge batteries up to 96Ah within 24hours.
For 12V batteries from 8,5Ah to 134 Ah for 24-7 battery maintenance. Can recharge batteries up to 67Ah within 24hours.
The time required for the OptiMate™5 to complete a charge on a flat but not severely discharged and otherwise undamaged battery is roughly equal to 1/3 the battery’s Ah rating, so a 60Ah battery should take no more than about 20-25 hours to progress to the Maintenance charge cycle. Deep-discharged batteries may take significantly longer.
The OPTIMIZE mode starts when the voltage has reached 7.2V / 14.4V for the first time during CHARGE mode.
Selection of the 6V or 12V charge program is done by pushing the select touch button. Disconnect the charger from the battery and hold down the button for 3 seconds to switch the program.
Yes, if the battery Voltage does not match the Voltage charge program, the OptiMate 5 6V/12V will not charge.
Similar models with different features.
In store packaging
MSRP = Manufacturer Recommended Retail Pricing. Price in EURO and GBP include VAT of 20%. VAT in your region may differ. Price in USD and CAD do not include sales tax.
IDEAL FOR: STD, AGM, GEL, SLI & DEEP CYCLE 6 & 12V batteries from 3 – 120Ah (up to 160Ah for 6V).
CHARGING AMPS: 4A (6V) / 3A (12V) (Ampmatic)
CHARGING VOLTS: 6V range: 0.5V – 7.2V; 12V range: 8V (0.5V*) – 14.4V
*Voltage safety check. Will not charge if battery voltage does not match selected voltage. User must confirm it is a low volt 12V battery > press selection button for 3 seconds to confirm > then lowest charge voltage for 12V is reduced to 0.5V.
FEATURES: SAVE & CHARGE all 6V & 12V lead-acid batteries.
USE: Indoor / Outdoor (lowest temperature: -40°F / -40°C).
INPUT: Global (100-240V 50-60Hz), high efficiency (CEC listed).
STYLE: Weatherproof case with wall mounts, with 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector.
SAVE : Low Volt Start of 0.5V + 2 step desulphation recovery.
SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected.
INCLUDED: weatherproof battery lead & battery clip set.
WARRANTY: 3-year limited replacement warranty.