OptiMate PRO-4 DUO
MSRP $619.95
PRO series: 12V 5A automatic diagnostic battery charger x4
OptiMate PRO-4 DUO is the automatic diagnostic charger for 4 x 12V Pb lead-acid (STD, AGM, GEL) and/or 12.8V LFP lithium (LiFePO4 / Lithium Ferrous Phosphate) batteries.
Four fully independent 5 Amp charging stations / banks, each with 3 Selectable modes to service NEW and USED powersport batteries, including 12V Pb (lead-acid, AGM, GEL) and 12.8V lithium (LiFePO4 / LFP) – activate 4x NEW, or save and/or charge and test 4x USED batteries!
Activate or prepare new batteries within one hour (60’), including Pb (lead-acid, dry-charged AGM) with separate acid pack, factory activated Pb (AGM & GEL) and LFP lithium delivered in sleep mode and/or requiring a top up charge – correctly prepares new batteries for best performance and to prevent early failure.
Automatically save any type of deep discharged battery from as low as 0.5 Volts, additionally for LFP lithium, manually reset the protective BMS and save from zero volts – dead-flat, neglected batteries can be recovered!
State of health test for GOOD (80 to 100%), OK (60 – 80%) or BAD (below 60%) batteries – confirms if battery is Serviceable or should be replaced.
Designed for the global professional, including battery service, new powersport vehicle and/or new battery sales – service orientated product designed for continuous use.
Each bank delivered with a replaceable output cord and fused battery clip set, AC power cord is replaceable / exchangeable – premium cables, internationally available.
MORE FEATURES:
|
|
|
|
√ Power Factor Correction √ Synchronous Rectification |
Video
FAQ
The PRO series is a range of professional battery charger-testers, ideal as workshop tools for retailers. A PRO series charger has selectable charge programs and advanced PRO features.
Pb: for 12V lead-acid (STD / AGM / GEL) batteries.
LFP: for 12.8V / 13.2V LiFePO4 batteries.
60′: A shortened program with charge time limited to 60 minutes or 1 hour, suitable for first charge / activation of a new battery, or a quick recharge of a healthy used battery with voltage higher than 11.4V. NOTE: If no selection (Pb or LFP) is made prior to connecting a battery for charge, the 60′ mode becomes the default selection.
To make a charge mode selection press and release the button once for Pb, twice for LFP or three times for 60'. Continuing to press and release the button in rapid succession will cycle selection from Pb through to 60' and then back to Pb. If no further selection is made for 3 seconds the last selected mode LED brightens to confirm selection is now final.
NOTE: If no selection is made 60sec. following connecting a battery for charge, the 60' mode activates automatically. To change selection, disconnect the battery, wait for the program to reset (confirmed when all LEDs flash together twice) and then return to a). Alternatively, turn off AC SW1 to reset all charge banks / stations.
The 60' mode is a shortened program with charge time limited to 60 minutes or 1 hour, suitable for first charge / activation of a new battery, or a quick recharge of a healthy used battery with voltage higher than 11.4V.
Always charge before first use. New LFP/LiFePO4 batteries are subject to international transportation limitations and may be delivered with a 30% or less state of charge. Batteries fitted with resettable overdischarge protection may be delivered in 'sleep mode' i.e. power to the positive terminal has been internally disconnected i.e. no voltage will be measured at the battery terminals/posts. During storage the battery may have lost further charge.
Yes, even if the batteries are connected in series they can still be charged without being disconnected from each other.
Connect a charge bank to each battery individually, as if the batteries are not connected to each other. Each charge bank works independently with only the battery it is connected to.
Models
One model with different AC cord options.
TM-670 with TA-31 AC cord.
TM-670 with TA-30 AC cord.
TM-670 with TA-32 AC cord.
TM-670 with TA-33 AC cord.
TM-670 with TA-37 AC cord.
TM-670 with TA-38 AC cord.
Find my plug? 
More
Includes 3 accessories.
1. AC power cable that matches your region –
2. Output cable extender (replacement SKU O-43) –
3. Battery Clips with fuse (replacement SKU O-14) –
BUY
MSRP = Manufacturer Recommended Retail Pricing is displayed above. (Currency selector > top right).
Price in EURO and GBP include VAT of 20%. VAT in your region may differ. Price in USD and CAD do not include sales tax.
TecMate do not sell product directly to the consumer. Find your nearest retailer by selecting the appropriate model below.
TM-670 with TA-31 AC cord
TM670 with TA-30 AC cord
TM670 with TA-32 AC cord
TM670 with TA-33 AC cord
TM-670 with TA-37 AC cord
TM670 with TA-38 AC cord
Specifications
IDEAL FOR:
- 12V lead-acid (STD / AGM / GEL) batteries
- 12.8V / 13.2V LiFePO4 batteries
- NEW Pb & LFP batteries without BMS
CHARGING AMPS: 0.2A to 5A variable (Ampmatic)
CHARGING VOLTS: 12V lead-acid: 0.5V to 14.4V. 12.8V/13.2V Lithium LFP (LiFePO4): 0.5V to 14.4V. 60': 11.4V to 14.4V.
OPERATION: Selectable
- Pb: for 12V lead-acid (STD / AGM / GEL) batteries.
- LFP: for 12.8V / 13.2V LiFePO4 batteries.
- 60': A shortened program with charge time limited to 60 minutes or 1 hour, suitable for first charge / activation of a new battery, or a quick recharge of a healthy used battery with voltage higher than 11.4V. NOTE: If no selection (Pb or LFP) is made prior to connecting a battery for charge, the 60' mode becomes the default selection.
Steps: 11
USE: Indoor rating IP40.
INPUT: Global (100-240V 50-60Hz), high efficiency.
STYLE: AC Class 2 input socket, with ON/OFF switch, 15cm / 6" output cord.
INCLUDED CABLES: Class II AC cord suitable for region, O-43 charge lead extender 180cm/72" and O-14 fused battery clips.
WARRANTY: 2-year limited repair / replacement warranty.
Documents
